Have frontier safe. w no ser# S&G dial & ring. L handle 7" c-c below dial. Safe measures 24"dx 30wx60 tall. Have (said) combination. 1-5 high & low, dead blow hammer doesnt work, nor rocking dial. Only feel DI when turning clock wise @ 96. nothing to C- clockwise.
I'm looking for lock orientation. Drill points, lock & relocker & any helpful hints to open wo drilling. I was told there may be glass hard plate. ?? If so, is relock tied to that hard plate? ...

Attached Thumbnails

 

Originally Posted by Mike McLean

I have purchased every single book and trade article i can possibly find. So many articles refer to decoding lock thru change key hole. Yet nowhere teaches how to actually do so. If anyone knows of an article or book that explains this process,please share. i have numerous practice locks, S&G, Lagard, Chubb, not to mention elocks as well. I dont understand how to decipher wheels 1 and 2 thru the changekey hole and beneath wheel 3. i understand how to map a wheel thru rivets and balance holes.

...

Can anyone give me details on this safe. I need to open it and need to know a drill point to view the gate/fence. Is the lock mounted vertical right and is there a glass relocker?

Attached Thumbnails

 

Anyone have pics and info on this safe. It was given to a customer , the people didn’t have the combo

Attached Thumbnails

   

Trying to figure out the handing of the lock on Haymen Floor safe. I then will know where to drill

Attached Thumbnails